Un acumulador de succión es utilizado para evitar que el líquido refrigerante vuelva al compresor. El acumulador es comúnmente usado en bomba de calor, refrigeración para transporte, sistema de refrigeración para cámara de baja temperatura y en cualquier lugar en que el refrigerante líquido en el retorno pueda preocupar.
El acumulador es instalado en la línea de succión anterior al compresor. Generalmente, es un recipiente vertical con un tubo en U interno. En la parte superior opuesta de ese tubo U a la salida, está abajo de la parte superior del recipiente. Esto permite que el acumulador quede prácticamente lleno antes que el nivel de líquido llegue a la salida del acumulador.
Un agujero de pequeño diámetro se hace en la parte inferior del tubo en U en su punto más bajo. Este agujero permite la recuperación del aceite eventualmente acumulado volviendo al compresor por este agujero.
Muchas veces se hace necesaria una fuente de calor dentro del recipiente para evaporar el líquido refrigerante. Esta puede ser un resistor eléctrico o camisa calentadora en el cuerpo del separador. Algunos acumuladores tienen conexiones con un sifón de línea de líquido en el fondo del acumulador que enfría. Esto mejora el desempeño del sistema por el sub enfriamiento del líquido refrigerante y protege el compresor contra golpes de líquido, al mismo tiempo en que súper recalienta el gas de succión.
suction accumulator
A suction accumulator is used to prevent liquid refrigerant returns to the compressor. The battery is commonly used in heat pump, transport refrigeration, cooling system for low temperature chamber and in any place where the liquid refrigerant in the return is concerned.
The accumulator is installed in the suction line prior to the compressor. Is generally a vertical container with an inner U-tube. At the top of the tube opposite to the outlet U is below the top of the container. This allows the accumulator remains substantially filled before the liquid level reaches the exit of the accumulator.
A small diameter hole is made in the bottom of the U-tube at its lowest point. This hole allows the cumulative oil recovery eventually returning to the compressor through this hole.
Often times it becomes necessary a heat source within the container to evaporate the liquid refrigerant. This may be an electric resistor or heating jacket in the body of the separator. Some batteries have connections to siphon liquid line at the bottom of the tank that cools. This improves system performance by the sub cooling the coolant and protect the compressor from liquid slugging, while that super heats the suction gas.
Agregar un comentario